Answer / sapna

electrical circuits deal with high value of current and
voltages wheras electronic circuits carry low current and
voltage

Answer / reena

Electric ckt consist of resistor, inductor, capacitance.

Electonic ckt consist of diode,gate etc.In case of electonic ckt we have to take care of internal resistor very care fully.

Also,Current rating in case of electronic ckt is very less as compare to electric ckt.

Answer / arnaldo valencia

Electric ckt are composed of hard wiring components like
motor starters eg. Star-delta, start-stop,and any reduce
voltage and reduce current motor starters.We can consider
the house wiring as elctric ircuits too, because those two
examples are using a minimum voltage of 24volts up to 440
or higher.
Electronics circuits are compose of a semi conductor
components like resistors, diodes,transistors printed
circuit boards and other semi conductors components.We can
call electronics circuit as a very sofisticated circuit
that can be used for controlling the motors speed,output
voltage and output currents and it always uses small
voltages for there coponents.

Answer / vilas

Electrical circuit generally deals with more than 24 volts
consist mainly power circuit and control of ,relays,
contactor,motors ,load component.Whereas the electronic
circuit deals with voltage lower than 24 volts, consists
diodes, resistors, transistors,plc,and electronic controls

Answer / bivash roy

In which current passes through a conductor, it's called an
electrical circuit And in which circuit current passes
through semiconductor or vaccum it's called an electronics
circuit.

Answer / muhammad salam

electric ckt is thst ckt which consist of passive components like resistor,i.e not suppported by external sourse,while elecronic ckt is made of active component like diode , transister along with resistor,capacitor snd inductor

Answer / ghulam jaffar

Electrical circuit consist on high And minimum 150 or 100 volt bt electronics circuit consist on low voltages & low current

Answer / shri..

But in telicommunication systems are using -48 volt

Answer / vilas

Electrical circuit generally deals with more than 24 volts
consist mainly power circuit and control of ,relays,
contactor,motors ,load component.Whereas the electronic
circuit deals with voltage lower than 24 volts, consists
diodes, resistors, transistors,plc,and electronic
controls,+48 and -48 volts in the electronic
telecmmunication,with high frequency,

Answer / amit pandey

Basicaly in matter of electrical:it worke at low friquency
and high power.
but in electronic: ckt it worke on high frequenc and low
power.

what is main advantage if motor connected in star or delta?

3 Answers   Essar,

Dg pf .71 i am improve pf 0.80 what capacitor connected in dg how?

0 Answers   AVT Natural Products, EMC,

how you connect the induction motor first in star and then delta in star-delta starter

1 Answers  

WHAT IS THE DIFFERENCE B/W THREE POINT STARTER AND FOUR POINT STARTER

1 Answers  

wat is d diffr btw shunt coil and trip coil in VCB?

0 Answers   NTPC,

can we use ordinary transformer in place of autotransformer?give reasons also

1 Answers  

what is Different between Bilinear and Unilenier?

0 Answers   ABB,

Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.

0 Answers  

what is corona effect

3 Answers  

How much pole motor can be desion for 415 volt ,50 hz.Power supply. in pratical condition . Prakash veer singh

5 Answers  

why they charge more bill for low power factor rather than high power factor

2 Answers  

Is there is any hazard to insulation of 3hp motor 5 KV megger is used for it?

1 Answers