Interested to Buy Any Domain ? << Click Here >> for more details...
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
what is power factor? is it good or bad for a system? what will happen if power factor increase or decrease?
Bhel,
4 12381why it is in star to delta form of Synchrounus generator and delta to star form of Generator Transformer (or step up transformer)
1 4630hey guys i recently saw a long transmission line in which a sort of balloons in red and white color were hanging at each section.do u have any idea why are they kept for?
3 7320what is the formula for calculating milliampere at different pressure points for eg 4-20 ma = 3-15 psi but if i have to check the ma at 4.6 ma?
4 27433we all know that corona is nothing but ionization of air around the conductor and there by allowing current to pass through ionized air.but we are not getting any short circuit in between the respective phases though the air turned as a conductive media between them??
1 4325in case of induction motor when overload condition or any short ckt. why stator winding burn not to be rotor winding
2 4949
how to enter inverter parameter? without manaual?
What is the C.C in motorbikes?
Is there any Institution for giving M-tech in Electrical engineering for those who r in service? Give the details please.
What are pcbs?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
What are the different types of flip-flops?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
i want sample question paper for SECTION ENGINEER IN RRB.
how to relay switch sense the fault?
In how we connect watt meter for open & short circuit test of a single phase transformer.
What is the previous name of Cox's Bazar
What are two contours of nichols chart?
what is the water-cement ratio of mix design while 30mpa in 7 days?
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
