Interested to Buy Any Domain ? << Click Here >> for more details...
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
What is mean by powerfactor. What is the difference between leading and lagging power factor?
HCL,
2 9106what is the difference between active power and reactive power and apparant power in practical as well as theoritical
1941hai friends please send me the previous question ntpc questions both tecnical and apptitude papers for my mail. and also post me the areas in which u have faced difficulties that might help ful to me. so please send the answer to my question. my mail id is sweety4834u@gmail.com
1993CAN ANYBODY PL TELL ME WAT FACTORS CAN CAUSE UNDERVOLTAGE ON A BUS??? PL LIST ALL THE REASONS WITH SOME EXPLAINATION
3 6071
What is parallel to serial conversion?
Can we put 3 layers of cable tray while installing tray
What is the standard of cotton yarn count?
What is the type of feedback used in an op- amp schmitt trigger?
What is the world's hardest metal?
Discuss-Toga & stola.
Purpose of stern tube sealing
1.Z transform always lies around ? a) origin b) pole c) zero d) z=1. Multiples Mcqs which is bother me can’t find answers on internet. Some help required with little explanation . Note: this is not homework or related to any test. Thanks
wat is an ethernet
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
What are the inspection and test plan for lift materials?
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
what are all the requirements to build a small robot,which can work to certain distance? (please give a detailed requirement)
why we using different type of microwave antenna we using like one is connected to MMU and one more is connected to other slot what is use of both antenna?
