There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
Hi, I am Jose. I am an Mehcanical Engineer. I am planning to appear for BHEL ET exam.Can any one help me how to prepare fo this test? Is there any question paper pattern for this test?
I am doing apprenticeship training at HT switch yard in NLC. How can i get electrical c license. ??? What r the rules for getting it as an apprentice? ??
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
what is tooth profile
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
hwat type of motor is used in thermal gas turbine hydro nuclear power plants and why
How to design a software ic using vhdl?
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
What is jet plane?
Do you know what is bolt?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
why various test are performed on electrical panels & power cables before commissioning on site & what are these test???
what is the difference b/w pvc cu conductor and cu breaded wire..?