Interested to Buy Any Domain ? << Click Here >> for more details...
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
Plastering with cm 1:5 mix( one cement and five sand ) to 12 mm thick. How much Bag of Cement (50 Kg) and Sand (Cum)
4 16720i am trying to select the correct grade steel for a shaft that will have a flap on it weighing about 4.5 tons being forced up with hydraulic rams. can someone tell me what grade the shaft should be and if it should be stainless steel or not
2 4520when a pure dc signal is sent through a moving iron meter, what will it read?? dc or rms?? when a variable dc signal is sent through a moving iron meter, what will it read?? dc or rms??
GATE,
1 2884what is an isolation transformer??? what is its purpose??? what happens if it is not used where it should be used?????
2 5227how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
2184
What Is C.G. And M.I. in simple
how to calculate range of level transmitter?
how to check three phase motor torque value?
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
What is multiplexing? Explain its primary advantage.
what is meant by residual over voltage & residual earth fault ?
xfhnchncv?
Explain the difference between shear center flexural center of twist and elastic center?
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
what is the difference between np2 and np3 concrete mix
How to convert GSS duct volume in KG for all guages
What is the sensitive part of the liner
what is your role of in previous company as a construction manager
what is wave length were using ?
Why silicon type transistors are more often used than germanium type?
