-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
I'm generating a pulse of 3V with frequency 80Hz (12.5ms time period) and pulse duration 0.125ms and feeding it to a transformer since i want the pulse to get amplified around 60V. At the output amplification s happening but the pulse is changed to a spike, can you tell me what could be the reason? (an ordinary transformer 220V-12V stepdown transformer is reverse connected ie. now it is 12V-220V stepup and voltage amplification happens)
1453If a generator of generating station produces 100MW rated output then what will be the rating of the step-up transformer connected to it?
5 5052Q : How to calculate cooling water pumps head, do I need to consider static head and frictional loss of the pipe with high elevation? I mean to say is discharge pipe branches to several elevations and joins to the cooling water return line. The highest elevation pipe goes to a heat exchanger at (xx) psi inlet pressure. Should I consider only pump discharge header and this piping for head calculations? How about frictional losses in return pipe? Pressure recovered in return piping is good enough to make it back to the cooling tower?
1 9861as we see that in our country the power rating for transmission is always rated in multiple of 11 like 11kv,33kv,66kv132kv. So i want to know wht is reason or logic here.
2 3279
Define the overload capacity of the motor?
trasnfarmaer core make
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
Difference between pre-tensioning and post-tensioning.
what are the interview question asked in wind mill about electrical
difference btwn channel and carrier in telecom?
What are the demerits of passive filters?
In a tractor, how the hydrostatic propulsion systems work?
Draw a parallel circuit with one battery and two resistors. Derive the formula for resistance?
give me all the details about the interview and which type of question being asked
what is the relative size of single and three phase?
When the relative speed between the magnetic fields of stator and rotor does is zero under steady state operation?
What is the significance of the bandwidth of an amplifier?
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?
What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller
