What is the difference between soldering & brazing?

Question Posted / hemant

3 Answers
5991 Views
UltraTech, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is the difference between soldering & brazing?..

Answer / ab_ina7

i) In soldering, filler material used have liquidus not exceeding 800'F (427'C)and below the solidus of base metal.....but in brazing filler material used have liquidus above 800'F(427'C) and below solidus of base metal.

ii) soldering is used for joining steel, copper and other materials at a low temperature where relatively joint of less strength are sufficient.........Brazing is used where a ductile point is required which will have not only good strength but also resistance to corrosion.

Is This Answer Correct ?

7 Yes

1 No

What is the difference between soldering & brazing?..

Answer / raghu

Soldering Brazing
Its is temporarily joint It is a Permanent Joint
Its use in electrical Its use in mechanical
Its mixture of Copper & Zinc Its mixture of Brass & Zinc

Is This Answer Correct ?

8 Yes

5 No

What is the difference between soldering & brazing?..

Answer / aamir pathan

soldering is the process by means we can joint two metal by
electric resistance by using brass and zinc

brazing is the same processs like soldering
but
temprature is high and joint is bigger than brazing

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Mechanical Engineering Interview Questions

What is the basis of selection of type of pump (Centrifugal, Vertical Turbine)

2 Answers DAE, DCSEM, Energy Plus,

boiler fusible plug melt down, normally melt down due less water or feed pump failure, but is there any possibility of fusible plug melt down due to high temperature in firing zone and at that time water level is perfect at it's level.

1 Answers

what is the diffrence betwen primary pumps and secondary pumps in aircoditioning field

0 Answers Carrier,

Whe a system is said to be

2 Answers

What is the structure of pure iron and whether it is soft or hard ?

0 Answers

What i the role of a turning gear attached to a shaft line of a steam turbine

2 Answers

What is the trunk type and crosshead type piston

1 Answers Honda,

Identify the parts of indicator diagram?