why neutral and earth should not be connected on 3 phase 440v/50c/s supply at consumer side. where as on 25kv/ac/50c/s railway traction substation neutral and earth will be connected and track at substation. and track will act as neutral and earth. Reasons for this is needed urgently
4 7530how to calculate interface capelary level transmetar lower S.G.0.54 and uper S.G. 0.26 and h=490 mm
3 5277what is the current rating of both primary and secondary of 500KVA,33KV./4ooV.distribution transformer.
1 3188Why Nutral CT rating for Earth Fault Protection of Transformer neutral shall be 20% of Full load Current of Transformer
2 3982
Can you any one explain application of buccholz relay operation and pressure relif device operation of power transformer
what is the calibration procedure for magnetic flow meter @ onsite
with the aid of schematic and block diagram describe the control system involved in a student passing a control system engineering examination.use standard terminologies and specify all the system component involved.
Explain about 3 phase motor fault current calculation with examples?
what is dry and wet frequency withstand voltage? why & where it is used??
what happens if dc supply is given and the remedies for it.
whats the coloring code of a air to open or a air to close valve?
What happens to voltage when current through the inductor is constant?
Explain the working of an electronic level troll.
why dont call datareader is backward
operation of diesel generator
Mention the quality parameters.
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
What is monolithic ic?
What is the difference between isolators and electrical circuit breakers? What is bus-bar?