Interested to Buy Any Domain ? << Click Here >> for more details...
why we need external pull up for port 0 of micro-controller
8051?
- 2 Answers
- 5951 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / shantanu
Pull up & pull down resistors must be requird I2C & Micro-
controller/ADC. The output port will be tri stated means 1
or 0, we can't prdict.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / shaveta
if pull up resistor is not added then the output will not
predict....without this resistance the circuit is called pull
down...
| Is This Answer Correct ? | 0 Yes | 4 No |
What is meant by pwm control?
What is non-weighted code?
Why sinusoidal waves are mostly used for communication rather than any other waveforms..please give 4 reasons
what is d basic difference between a latch and a flip flop ?
Explain the different modes of flyback converter
state the barkhausen criteria?
what is Active device and Passive device?
What is meant by mcmurray inverter?
How many types of resistor are there in diode?
Where is the maximum temperature in refrigeration cycle? a.Between evaporator & compressor. b.At Compressor c.Between compressor and condensor. d.At condensor
can we conect lowpass filter before high pass filter in cascade form in band pass filter?(active filter).
What is negative frequency?
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
