1. Categories >> Engineering
  2. Suggest New Category


Engineering Interview Questions
Questions Answers Views Company eMail

calibration of instruments.

ONGC,

11 16552

capacitive transducer : dielectric type.

ONGC,

2 7264

How can we share data between actions in qtp..pls tell me

Datamatics,

1796

mod 6 counter : no. of FF used.

ONGC,

17 25573

3-4 ques of instrumentation : data based.

ONGC,

1611

i need ongc engineer trainee electronic test questions

 2076

what is the thermodynamics?

8 11799

i am b.sec with PCM now what can i do for higher education

1483

How will u calculate wire size according to current rating?

Global Computer,

2 8053

What will happen if 230V DC motor connected to 230V AC Supply?

Ashok Leyland, BOC, JSW, ONGC, RRB, TRB,

15 58003

Normally we say cellphone is a embedded device but computer is not a embedded system. Today cell phones have the facility to install software. so the cell phone is embedded or not

 4 6414

The microcontroller perform one function at a time.whether it is advantage of microcontroller or disadvantage of microcontroller

 4 6437

Two electronic energy meters are connected to seperate phase wires, but connected to a looped neutral. Are these going to function correctly?

DRDO,

8 11317

generally how much percentage is required to sit in exam of PSU'S for mechanical engg. candidate (general category)

 2435

Paper Details: company -- Hindustan Copper Limited post -- GET 2008 Date -- 03.08.2008 Dept.-- Electronics?Instrumentation Aptitude -- 70 Technical-- 80 Total Time -- 2hr 30min I have listed the question I could able to remember 1. BCD equivalent of 43 2. value of K for stability of a system from a given equation 3. transformer connection for darlington connection 4. damping of balastic galvanometer 5. advantage of chart-pen recorder over CRo 6. CRO - how to change bandwidth 7. questions on CRO construction 8. reverse saturation current of si diode 9. advantage of wire wound resistance over carbon resistance 10. core material for a small coil 11. max fanout-- TTL/ECL/CMOS/MOS 12. component of resistance of monolithic IC 13. functions of capacitors in multivibrators 14. to change a sawtooth signal into a square wave we use-- schmit trigger/ schottkey diode/ zener diode 15. relation b/w á & â in transistor ckt 16. function of SiO2 layer in fabrication 17. 3 questions on ODD MAN OUT

HCL, L&T,

2 4938

Un-Answered Questions { Engineering }

what are the steps involved in generator load test?

1101

Show the sinosoidial effect built in a generator with the help of a diagram?

644

where do i get previous question papers of metallurgy?

2053

How much Tolerance factors like 1. brick work 2.plaster 3.painting 4.floor tiling 5.wall tiling 6.shuttering 7.concreting 8.steel

1390

I am from B.Tech back ground, i had Applied to do masters in Engineering management, and university gave Admission and sent I-20, if the interviewer asks why are doing masters in this field, even you are from B.Tech (information technology)? Can any one give me relevant answer, if interviewer asks that question

1530




What is the difference bitween control net scaner and device net scaner

2958

How bhp is measured?

573

why we transfer FA(full arc) to PA(partial arc) in steam turbine at specified load?

1743

what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail

1325

how to compute kAIC?  with formulas...

3696

where the lexical paramater will use in fron end?

1451

how will u send the idoc

2129

WHAT R THE DIFFERENT CONFIGURATIONS OF FPGA

1594

how to calculate cooling requirement of datacentre from electrical load?

1868

What do you like and dislike about working for this organisation?

4374

For More Un-Answered { Engineering } Questions Click Here