if u have three steam turbine blades, how will u find which blade is for low pressure, high pressure and medium pressure?????
5 8210If we give 2334 A, 540V on Primary side of 1.125 MVA step up transformer, then what will be the Secondary Current, If Secondary Voltage=11 KV?
L&T,
3 6480Suppose you have hot fluid and cold water, what fluid you should flow in shell side and tube side in a shell and tube heat exchanger and why
6 10368Suppose you have hot oil and cold water, what kind fluid you flow In shell side and tube side and why?
5 6411
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
DERIVE AN EXPREION FOR MAXIMUM POER TRANSMISSION, WHAT ARE ITS APPLICATIONS.
What is the principal of axial pump?
in one hour , one 200 excavator , how much quantity (mcube)can load ? soil is not hard not soft
Insights of tri-state inverters?
What is lathe bed made of ?
How to convert 20 dia bar to 16 dia bar in beam without reducing the steel weight
What are the reasons of removal of particles from effluent gas?
Do closed loops systems require manual input?
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
working principles of cf lamp,incandescentlamp and f lamp?
how do i work out the Amps of a incommer if i am running 1 37 KW motor and a 0,75 KW motor and some solinoids
What is the strength of cement?
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?