Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) We have a 1275KVA existing Transformer in a power plant project. Customer want to get it test & confirm whether it is a Dyn1 Transformer or not. Pleae let me know how to test it.
1 3968why Transformers power mentioned in KVA?. and why Generators and Motors power mentioned in KW?.
10 14531What is the purpose of Rotor earth fault relay and How to test the Rotor earth fault relay in generators and What is the procedure?.
1 4418we have read that when the piston goes up and down then the engine works i.e. the suction,compression etc etc. then what happens in the case of big vehicles, which start at stable condition, i.e. how does their piston moves when they are at rest. how suction,compression etc
Bhel,
5 7591why there is no current in the rotor body althrough the flux linking with it also get changes. why current only flows in windinds not in rotor
1 5418why we use condenser in the thermal power plant, althrough the same vapour will be again heated
Bhel,
2164WHEN SINGLE PHASE SUPPLY AS 220V, WHY THE 3 PHASE- 4 WIRE MEASURED AS 440 VOLTS INSTEAD OF 660 VOLTS (220 VOLTS PER PHASE i.e 220x3 = 660 volts ).
1 6375In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
1979
Describe the qualities of a successful entrepreneur
why r u using enjine oil inside of diesel generaters.what is the uses & why r using diesel by pass filter. plese kindly answer me sir..?
what is the importance of signals and systems ?
what is the grounding Calculation formula? spouse i want to provide grounding to 3phase 18kw motor or i want to provide ground to 3phase 10kva dry type transformere or you give me any exemple...... Thanks.
Dear all, I am working as engineer in an electronics industry since 3 years,and i would like to apply PR visa for australia,i got 6 bands in all modules in ielts(general).please let me know what should i do now?
what is the significance of tan&delta and how it performed in power transformer
How good are the Weinerberger Porotherm bricks that are being used in construction in Chennai, India. Its being used in non load bearing walls and has a compressive strength greater that 35 kg/cm^2 and a density of approx.694 - 783 kg/m3.
what is difference between 2 pole structure and 4 pole structure in transformer yard
where i can get soil testing report for construction in aurangabad.
Explain conductivity, resistivity and resistance?
What is the best way to configure a bypass line in slurry services?
How to measure the insulation resistance for printed circuit boards?
How much pressure on air reservoir?
Is there any relation between Artificial Intelligence and Instrumentation?
while doing the structural works of a simple ground+1 villa, can the columns be continued immediately after neck columns without tie beam, while the tie beam to be done after columns concreting.