Answer / jaaaan

In induction motor armature winding is connected as closed loop
In syncronous motor armature winding is connected the dc supply

We are just connect the dc supply to the armature supply throuh the slip rings

Answer / raja

(1) U can remove the rotor of the 3 phase induction motor
and put the armature of the DC motor.

(2) supply DC suppy through the slip ring of the 3 phase
slip ring induction motor

what are the deffects for failure of PLC?

0 Answers  

---

what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????

0 Answers  

---

Explain Power factor in simple words

1 Answers   ETO,

---

application s to shunt coil

0 Answers  

---

How cmd is calculated in case of energy neters

0 Answers  

---

how technical is calculated in 11kv line and lt line

0 Answers  

---

suppose there is afault in transmission line connected to a generating station, then what r the adjustments u will take to without loss of synchronism?????

2 Answers   NTPC,

---

What is use of starter and choke in tube light

0 Answers  

---

What is meant by CFL & PL lamps

1 Answers  

---

what will happen if dc motor given ac supply

11 Answers   Mahaveer,

---

if we know Fault level say 25 KA , How to decide busbar size for Distribution network of 1000 Amp Breaker ? Sample Calculation or Farmula Available or not ?

4 Answers   TCS,

---

Can we install and run MCCB suitable for 440v 3Phase 4wire system, on a 220V 3Phase 4Wire System.

3 Answers  

---