Answer / lodhi

NECESSITY OF SCANNING:-
scanning is necessary becausa if we want to transmit the
whole picture frame in a oncetime it require large
bandwidth . so, we divide the whole frame into pixel . so,
as the scanning is start the picture is pixel by pixel
transmit and it require less bandwidth and it is done at a
faster to remove the flicker and to show continuity in
picture...

Answer / sachin

to remove the flickers and to show a continuity in a picture
motion.

Answer / badzhah

Scanning is done at fast rate and the rate depends on the
perceptiveness of the Vision of eyes. So that the image
appers to be a moving one

Answer / jeff

scanning is the important process carried out in a
television system in order to obtain continuous frames and
provides motion pictures

Answer / sayem

Scanning is the important process carried out in a television system inorder to obtain
continuous frames and provides motion of picture. The scene is scanned both in the
horizontal and vertical directions simultaneously in a rabid rate. As a result sufficient number
of complete picture of frames per second is obtained to give the illusion of continuous
motion.

Answer / rakshit

it's necessary to present the picture to the eye in such a
way that an illusion of continuity is created and any
motion in the sence appears on the picture tube screen as a
smooth and continuous change

Answer / umesh chander

A process is carried out in the television system and scan picture in both horizontal and vertical direction to provide sufficient number of complete picture or frames per second to give the illusion of continueously motion.

We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?

0 Answers   DSPM,

Explain how the active power factor correction changes the wave shape of current drawn by a load to improve the power factor?

0 Answers  

temperature transmitter range o to 100c over range set value 21.6ma if you give source on the field transmitter showing iop out put also 21.6ma but dcs not showing iop samething if you simulat from hart 21.6ma in dcs showing iop how its possible?

0 Answers  

explain osi model???

1 Answers   Nokia Solutions and Networks,

what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?

0 Answers   Wipro,

hi...i had completed B.E.in Electronics & Communication.i had applied Section Engineer in railway recruit ment 2012.I need previous year exam papers.

0 Answers   RRB,

IN GENERAL PRACTICE HOW KVAR AND CAPACITANCE VALUE OF CAPACITOR CALCULATED?

1 Answers  

Convert the 16 W power into dBm.

1 Answers   NSN,

At what voltage does land line telephone operate?

0 Answers  

a man saves 40% of income if his income is increased by 20% expenses is increased by 10% then % increased in savings

4 Answers   TCS,

describe the bandwidth delay problem?

1 Answers   Hathway,

Why the shape of OP-AMP is triangular not other shape?

17 Answers   CH, CTS, GVV, Tata Power, TCS,