why ELCB's are not useful for operation theater equipments ?
Answers were Sorted based on User's Feedback
Answer / bernard zakaria
Why elcb can not work in Telecom DC power plants(-48VDC)?
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / abhilash
Operation theatre using life saving equipments,and even if
there is small leakage, the circuit will trips off and if
it happends during a major operation, it should not be
happen.
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / pravesh
as we knoe that elcb is earth leakage ckt breaker. it workd
on milli amp. of current in theaters if we use elcb there
may be chances of eath leakge current or may be a current
may flow through the neutral which may cause tripping and
equipment shutdown causing hinderance, so the elcb are not
used in theaters
Is This Answer Correct ? | 2 Yes | 7 No |
Can you any one explain different between instantaneous over current and IDMT
For an 100kw generator, only 50kw of load is connected. Will the generator generate only 50kw or 100kw. If it generate 100kw what happens to rest of the 50kw. What happens if we connect more than 100kw of load?
why auto transformer connected in star?
if we convert kw into kva,which one formula use by us,pls tell me?
19 Answers ABB, AEC, BGH,
why swinburnes test cannot be performed on series machines?explain
how dose servo motor works
What is the difference between LT & HT Cable
how many synchronous motor are there in any power plant
Why substation battery room is coulered black?
what is a pf factor in generator.
what is extra low voltage system
I BOUGHT A HAVELLS ACCL WITH GENERATOR STOP FASCILITY(i.e- BASICALLY IT IS A AUTO CHANGE OVER SWITCH) FOR MY HONDA EXK 2000S HOME GENERATOR (WHICH START IN PETROL & RUN IN KEROSENE). ACCL HAS 8 POINT. 2 FOR MAINS(PH & NUE), 2 FOR LOAD, 2 FOR GEN AND 2 FOR IGNITION POINT(X1 & X2). THE IGNITION POINT IS SPECIALLY FOR AUTO ENGINE STOP WHEN MAINS POWER RESTORE. I CONNECT THIS X1 & X2 POINT TO THE GENERATOR STATER MOTOR & EARTHING POINT. BUT WHEN MAINS FAILS THE GENERATOR COULD NOT START, BUT WHEN DISCONNECT THOSE X1 OR X2 POINT, THEN THE GENERATOR START. BUT WHEN MAINS ON THEN THE GENERATOR SHOULD START, AND WHEN I OFF THE MAINS THE GENERATOR AUTOMATICALLY STOP. PLESE HELP ME HOW I STOP THE GENERATOR AUTOMATICALLY WHEN THE MAINS RESTORE.