Answer / parimi.venkateswarlu

voltage in winding increase double,due to this effect flux
density increases to doubleit causs high no load losses and
may cause to distroy the core

Answer / sendhil

emf e=4.44BAfn volts
if the frequency is increased induced emf also increased so
the induced emf damages the insulation of the winding it
will leads to short ckt

Answer / vikramsena_reddys

as per EMF equation of the trasformer frequency is directly
proportional to winding voltage. if we double the frequency
the sinusoidal root mean winf=ding voltage also doubled.

E=4.44 * f*b*n*a*b

Answer / phkhatri

Follwing series of action will occur when 100Hz power is
applied to 50Hz transformer.
1) Core gets saturated
2) No,load losses increases and Temp. too goes up
3) Output voltage cannot be predicted as the core is
totally saturated.
4) Heating continous and gradually damages the core
5) This is followed by heating up of the oil and thus
cooling temperature goes down sharply.

Answer / r jp hansalkar

thye transformer iron losses will increase 4times as iron
losses is a function of the square of the frequency.As a
result of increased Iron losses temperature will shoot up.

Answer / prabal gohain

when frequency increases , Humming sound of transformer increases becz magnetic core has to magnetise and demagnetize at a rate double of its frequency. voltage is the amplitude of the sinusoidal wave(AC),so will not vary with frequency

Answer / muthuraj

The flux decreases only when voltage is kept constant and
frequency is increased. To keep the flux constant,
transformer draws more magnetising current. Further,
magnetic loss increases.

Answer / a.kossay

if we operate the transformer at 100 hz the magnetic flux
inside the core will decrease sharply making the output
voltage decrease

Define resonant frequency?

1 Answers  

what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?

1 Answers  

what topics we have to concentrate for power grid et.written test.and tell what to read for english synonyms and antonyms.

1 Answers  

What is the name of the winding to which supply is given?

1 Answers  

I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.

1 Answers   College School Exams Tests,

Why should we hire you over the others waiting to be interview?

1 Answers  

which is more danjerous high voltage or high current

0 Answers  

One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?

1 Answers  

Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?

1 Answers  

how the speed of the gets motor regulated. does it draw the same current on the all speed level.

1 Answers   Danko,

what is the difference between old fan regulator and new fan regulator

1 Answers  

why transformers not work at d.c.-

3 Answers