Interested to Buy Any Domain ? << Click Here >> for more details...
why in 8085 microprocessor some address and data bus are
same help me ...
- 8 Answers
- 13218 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / indu rana
In 8085 as well as in other microprocessors, we multiplex
address bus and data bus , so that no. of pins may get
reduce in an IC.
| Is This Answer Correct ? | 9 Yes | 2 No |
Answer / mudit
To reduce the number of pins to fit it in smallest plastic
packet we use latched data & address bus(8-bit data
bus&16-bit address bus )
| Is This Answer Correct ? | 10 Yes | 4 No |
Answer / vini
to reduce the no of pins so that it will fit into a small
ic.
| Is This Answer Correct ? | 9 Yes | 3 No |
Answer / ravi pailoor
CISC architecture has address and data buses on the same
lines. RISC architecture has different address and data buses.
| Is This Answer Correct ? | 5 Yes | 4 No |
Answer / ashish
because it has "vaun neuman" architecture which shares
address n data bus.
| Is This Answer Correct ? | 4 Yes | 3 No |
Answer / dhiv
inorder to reduce the external pins address bus and data bus are multiplexed so external latch is required for this ..
| Is This Answer Correct ? | 0 Yes | 1 No |
Answer / laxmi
to reuse same pin for address as well as data line
| Is This Answer Correct ? | 3 Yes | 6 No |
what is the diff btw address and memory location?
what is different between three phase balanced and three phase unbalanced load with chart.?
Although zener diode is operated in the reverse breakdown region, but it does not burn. Why?
Which was intel's first microprocessor
What is dma controller?
At what voltage does land line telephone operate?
what is the importance of clock frequency in microprocessor?
modern capacitors which have high capacitance in small size use a dielectric of?
Mention the operators that cannot be overloaded?
I am completed BE electronics and communication engineer I have 4 years experience in mainteance dept .am applying for c license is possible...How 2 get c license
how to calculet the resolution of 4 to 20 mA current signal
Hi dears, i work with E// switches since a bit time,i faces a problem with AFFILE output,when i get the out put (with Hex code) and i try to convert it to ASCII code it gives me the correct values but the data is not arrange correctly,there is some tabs,spaces and by result the data is shifted is there any advice for this case thanks & regards
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
