Question 64 – According to a heuristic of chemical engineering plant design, assume a pressure difference dP = 4 psi for each 10-ft rise in elevation. A pump is needed to pump liquid from a storage tank at a lower elevation to a heating tank at a higher elevation with the elevation difference of 60 ft. (a) Find the pressure loss due to such elevation. (b) If the required minimum inlet pressure to the heating tank is 9 psi, with 1 control valve is installed between pump and heating tank, what is the dP minimum required for the control valve and the entrance to the heating tank when the heuristic mentions that at least 10 psi is required for the control valve? (c) The pressure at the inlet of the pump is 8 psi and the flowrate of the liquid produces pressure head of 50 psi. What is the total pressure produced by the pump? (d) Assume a pipeline dP of 2 psi / 100 ft for liquid flow in a pipe according to heuristic, what is the approximate maximum length of the pipe in ft that can be installed between the pump and the heating tank?

1 Answers  

---

can we apply Bernoulli theorem for liquid?

1 Answers  

---

What's -74C, dew point is better the -70C dew point In draying unit .

0 Answers  

---

To how much height the liquid willbe thrown out to atmosphere from a pump with a discharge pressure of 5bar

4 Answers   TCL,

---

why we make urea prills , why we do not make crystals of urea,

1 Answers   IFFCO,

---

---

ENGINEERING MATERIAL - EXAMPLE 12.2 : At 150 degree Celsius, a mixture of 40 wt % Sn and 60 wt % Pb present, forming phases of alpha and beta. Chemical composition of Sn at each phase : CO (overall) : 40 %, CA (alpha) : 11 %, CB (beta) : 99 %. (a) State 2 reasons for the existences of alpha and beta phases for the mixture of Sn - Pb at 150 degree Celsius. (b) By using Lever Rule, calculate the weight fraction of each phase for alpha, WA = Q / (P + Q) and beta, WB = P / (P + Q) where Q = CB - CO and P = CO - CA.

1 Answers  

---

Explain what are the advantages of using gear pumps?

0 Answers  

---

The job profile as a Service Engineer?

0 Answers  

---

Question 108 - (a) The correct statement about both the average value of position (<x>) and momentum (<p>) of a 1-dimensional harmonic oscillator wavefunction is <x> = <p> = 1 - x. Find the value of x. (b) The probabilities of finding a particle around points A, B and C in the wavefunction y = f(x) are P(A), P(B) and P(C) respectively. Coordinates are A (3,5), B (4,-10) and C (6,7). Arrange P(A), P(B) and P(C) in term of a < b < c, when | y-coordinate | signifies the probability.

1 Answers  

---

CHEMICAL MATERIAL BALANCE - EXAMPLE 2.3 : A 1.5 weight % aqueous salt solution is concentrated to 4 weight % in a single-effect evaporator. The feed rate to the evaporator is F = 7500 kg / h and the feed is at 85 degree Celsius. The evaporator operates at 1 bar. By assuming that only pure solvent of water exists in the form of vapor from the feed, calculate the flow rate of such vapor V.

1 Answers  

---

What could be a possible cause for sudden foaming in a cooling tower?

0 Answers  

---

Question 46 - In a steady state one dimensional conduction with no heat generation, the differential equation is d / dx (k dT / dx) = 0. Prove that T(x) = ax + b, where k, a and b are constants. (b) At x = 0, T = c and at x = L, T = d. Prove that T(x) = (d - c) x / L + c for boundary conditions.

1 Answers  

---