We are facing the problem of communication failure between seimens drives and AB

We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?

Question Posted / lalit

0 Answers
1943 Views
DSPM, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electronics Communications Interview Questions

why we are using register of 1k,10k,100k,47k,330k in cell phone based voting machine project?

0 Answers

What are the control strategies of chopper?

0 Answers

What is a term "sweep" in Cathode Ray Oscilloscope?

3 Answers CodeVita, Student, TCS,

i want do telecom protocol development course from hyderbad convergence training school so what is the scope after doing that course and will i get a good job after doing the course and what will be the minimum package

0 Answers BSNL,

What are the differences between voltage and current controlled devices?

0 Answers

What is the effect of temperature on extrinsic semiconductor?

0 Answers

Trace Matrix Mapping Technique

0 Answers TCS,

about transmitter

1 Answers BSNL,

highest voltage gain can be obtained from a ).CC b).CE c).CB d).Both CE and CB

14 Answers Cisco, Ericsson, SRC,

Explain the difference between microprocessor and micro controller?