Why taper is provided in keys?why it is provide only one side?what types of stresse induced in keys?



Why taper is provided in keys?why it is provide only&nb..

Answer / nandu bisane

for easy insertion and removal of key taper provided to the key, key passes tensile, circumference,compressive stresses

Is This Answer Correct ?    11 Yes 4 No

Post New Answer

More Mechanical Engineering Interview Questions

"What is fuel oil viscosity, specific gravity?"

1 Answers   RRB,


Hi everyone.. I attended the HAL interview... on 9th dec 2008 @ Bangalore.. the interview was 90% technical... my question are>>>>> 1) Design a rod that should withstand 1000N? (they told that the material is mild steel & they gave me the stress- strain graph for that) 2) what is the principal of hydraulic braking?? 3) whether interchangebility is possible between JIGS & FIXTURES??? 4) what is recent developement in Automobile ENGINE??? 5) abt my final year project (since i m a fresher) 6) some HR questions

3 Answers   Bhilai Steel Plant, HAL,


What is the difference between kg/cm2 / Bar /psi in pressure units?

2 Answers   TATA, Tata Steel Limited,


What are the items to inspect after cylinder liner is pulled out

0 Answers  


Q : How to calculate cooling water pumps head, do I need to consider static head and frictional loss of the pipe with high elevation? I mean to say is discharge pipe branches to several elevations and joins to the cooling water return line. The highest elevation pipe goes to a heat exchanger at (xx) psi inlet pressure. Should I consider only pump discharge header and this piping for head calculations? How about frictional losses in return pipe? Pressure recovered in return piping is good enough to make it back to the cooling tower?

1 Answers  






what is the difference between: throttle valve,flow control valve, venturi??

1 Answers  


what is the trignometry of lifting tools using the wire rope ? any formula for trignometry ?

0 Answers   GE, ONGC,


Interview question paper

0 Answers   Bhel,


what is d diff. betn critical speed & whirling speed?

1 Answers   TATA,


1.What is the difference between safety valve and relief valve?

9 Answers   Covanta Energy,


If gas turbine is operating on part load, how droop will affect the output with respect to frequency.

0 Answers   GE,


what is the working principle of a vibration meter?

0 Answers   NPCIL,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)