Which modulation is good for Radio Broadcasting.
AM(Amplitude Modulation) or FM(Frequency Modulation)?
Answers were Sorted based on User's Feedback
Either of them may be considered "good" dependent on the service provided.
In the medium frequency broadcast band (535kHz to 1700kHz) a.m. is chosen because of its relatively narrow bandwidth - about 8kHz, so that many stations can operate in that band.
In the v.h.f. broadcast band (87.5MHz to 108MHz) f.m. is used so that the wider bandwidth necessary for reasonably good transmission of music, plus a 38kHz sub-carrier for stereo transmission, may be used.
In the aeronautical v.h.f. band, a.m. is used. This is to avoid what is called the "capture effect" of a stronger f.m. transmission overriding a weaker one, which could mean that a weak signal from an aircraft in distress might not be heard.
So, both a.m. and f.m. are "good" for broadcasting.
| Is This Answer Correct ? | 13 Yes | 0 No |
Answer / ashutosh mishra
Both the Modulation technologies are good for broadcasting and having their own advantages and disadvantages.
AM is conventional method of broadcasting.
With AM broadcasting (MW & SW)large distance can be covered but the interference of noice is increased with distance.
FM can be received in limted area only and can not be transmitted over long distance.Quality of Reception in FM is good in comparision to AM.
In television broadcasting both AM and FM are used simultaniously,one for picture and other for sound.
In india AM is used for picture and FM is used for sound.
| Is This Answer Correct ? | 4 Yes | 0 No |
frequency modulation is best for radio broad casting.
| Is This Answer Correct ? | 0 Yes | 0 No |
In a mosfet, what does the pinch off voltage refers to?
Explain how many mosfet switches are there in dynamic ram?
why is BPSK better than BFSK in presence of noise
how to determine AC frequency through hardware ?
What do you by interfacing in PC ?
what is colur code of resistor value 5.6kohms
What are the advantages of parallel optical interface?
what is ups and inverters. and how to give battery connections for ups.
What about the year gap criteria for HCL technology?
Why are ics so cheap?
Can anyone Explain about TRIAC ,SCR ,JFET , UJT in simpler words...
What are the applications of flip-flops?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)