what is difference btween rotameter and orifice plate?
Answers were Sorted based on User's Feedback
Answer / palanisamy
In orifice plate the area is constant & Dp is variable.
Whereas in the Rotameter the DP is constant & the area is
variable.
Is This Answer Correct ? | 23 Yes | 1 No |
Answer / asfaqh amir m
rotatmeter is maintaing constant differential pressure and
orifice plate does not like that it will differ.
Is This Answer Correct ? | 7 Yes | 4 No |
Answer / yakin patel
Rotameter it self flowmeter and orifice is obstracle plate which is used for flow mesurement in dp type trnsmitter
Is This Answer Correct ? | 5 Yes | 4 No |
Why drum level range is given -500 to 0 mmwc pls give me that answer
in split range control valve,two valve should be in two different line and that should have some distance,and we have only one positioner feed back link.so how we connect one feed back in two control valves?if you have picture please forward me.my email id kb.syamkumar@gmail.com
how to calculate control valve bonnet size?? or how to select its material?
We have ZR22G-100-S-A-E-T-T--E-A/CV/F1 Model Zirconia Oxygen analyser which is Yokogawa make. I kept the analyser in Flue gas path at Air pre heater area. My plant is 7.5MW Biomass power plant. For a particular fuel, Coconut Husk which contains Sodium and Potassium chlorides iam not getting proper reading, Analyser output always Zero. I calibrated the analyser and it is OK. For Other fuels like Wood chips, Cholam waste, DOB, Groundnutshells, Ply wood waste and all iam getting actual percentage of Oxygen. What is the main reason behind this draw back?
Any body have know try work calculation ???
what is difference between RTD , thermo couple and thermistor in general ?? (except temperature co-efficient )
why we set -10 volt in vibration sensor output,why not +10 volt
How many mode are in ups?
hello.my friends.i am an electronics & instrumentation engineer.i want to know Q1.why lugs use in instrumentation cable termination? Q2.if limit switch not working what to do?
it is possible to check the fail safe condition in pressure transmitter. if possible how?
why the positioner output is 3-15psi
Different between control valve and mov