Why do we use badarpur or crusher sand with coarse
aggregate in a concrete mix?
Answer / jitendergb
Coarse aggregate is always broken in unequal shapes it
helps in making interlocking in between all concrete mix,
but there remain empty space in between coarse aggregate
with out fine aggregate or sand like badarpur or crusher
sand, so just to fill the space and preventing concrete
from honeycombing and air pocketing in concrete mix we
always use badarpur sand or crusher sand in concrete mix.
Cement can not fullfill this empty space.
Is This Answer Correct ? | 15 Yes | 0 No |
Journal entry Gross salary 10000 Tax 1000 Employee contribution 2000 Employer contribution 2000
how to calculate the quantity of material in 1 cubic meter Concrete?
What is gravity flow?
How many no of cement bags required to do the concrete with the proportions 1:1.5:3 for 4inch thickness for 100 sqft?
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
How musch steel i.e. angles, channels,and square pipes are required per square feet for a steel roof of residential two storied building?
what is difference between design mix and nominal mix,where the design mix is used?
minimum dia of manhole cover should be A] 50 cm B ] 100 cm C ] 75 cm
can u use instead of water milk for concreting
What Is the Thumb rule to calculate depth and dia of pile required to carry specified load on differeent soil
What is the minimum compressive strength of a brick according to IS codes ?
30 Answers Arup, CCCL, GMR, L&T, Rachana Sansad, Theme Engineering, WAPDA Water and Power Development Authority,
what is the safe bearing capacity of hard murum? can we consider it 50 ton?m2