Answer / starry

angle modulation :it is the process of varying angle of a
signal ( carrier signal) with respect to instaneous
amplitude of another signal known as message signal.
***
angle in the sense either frequency or phase.

amplitude modulation :it is the process of varying
amplitude of a signal ( carrier signal which is with zero
reference ) with respect to instaneous amplitude of another
signal known as message signal

noise :
unnecessary things occured in the process of modulation
that may be either amplitude or frequency or phase.

Answer / srikrishna

The answer above is completely in correct.,sorry to tell
this.

ANGLE MODULATION means

the angle (here angle means the phase of the signal or
frequency of the signal),of the carrier signal is varied in
accordance with the message signal.
here we dont change the charicteristic of the message
signal we have to change one of the charecterisic of the
carrier signal.

Amplitude modulation means the carrier amolitude is to be
varied with respect tothe message signal.

Noise means the unwanted signal frequencywhich is probed
into the actual required signal and effects the
charecteristics of the original signal.

noise is a wide band signal i.e. it will present at all
frequencies but at some frequencies the effect of noise may
be low.

Answer / d.dinesh

Angle Modulation:

Varying the frequency of the modulating signal
(message signal) with respect to carrier signal to
get a angle modulated signal

Amplitude Modulation:

Varying the amplitude of the message signal with
respect to carrier signal to get amplituted
modulated signal

Noise:

Noise is unwanted disturbances in a signal

what is callibration?

1 Answers  

---

i)if we use f.m for video signals in t.v. what will happen?

3 Answers  

---

Write two characteristics of combinational circuits.

0 Answers  

---

Why is base made thin and lightly doped?

0 Answers  

---

where will be the transient condition in a diode?

0 Answers   RKB,

---

For a type a chopper (first quadrant), express the following variables as a function of vs, r and duty cycle
in case the load is resistive average output voltage and current?

0 Answers  

---

What is a stage? Explain its functioning.

0 Answers  

---

which is the best college to study engineering? why and list any 10?

2 Answers   TCS,

---

Why diodes should be connected in antiparallel with thethyristors in inverter circuits?

0 Answers  

---

How is thermal management done in electronic circuitry?

0 Answers  

---

Explain why an ordinary transistor is called bipolar.

0 Answers  

---

the two inputs to and gate are 4V and 5V.if threshold voltage is 0.5V.then what is output of and gate?if input voltage is reduced to 0.52V each,then what will be output?

2 Answers   Intel,

---