Answer / kumar kammath

For lower capacity you can use Ammeter in series. But for higher capacity use shunt resistor in series with the power circuit and connect Ammeter across that.

Answer / ashwin

tong tester

Answer / gurumoorthi

connect ammeter in series with the motor.....

what is the difference between arc and spark

2 Answers   ABB, Jindal,

---

"What is the difference between voltage and potential differnce?"

15 Answers  

---

what are the energy savings methods that are existing in coal based power plant?

1 Answers  

---

what is high tension ? specify the range?

3 Answers  

---

whenever any squirrel or a crow falls on the transformer input line then there is a big explosion and 440 volts of power is being discharged through the neutral line due to which appliances in off mode are also burned.we have earthing for the transformer as well as the bus bar chamber.why is it happening?

1 Answers  

---

how can we understand that where we have to use ac or dc coil for solenoid valve and why?what is the different between coil of ac and dc explain please.

0 Answers   TK Group,

---

why DG battery blast

2 Answers  

---

Which Class insulation is prefered for the sandwich Busducts ? Why?

0 Answers  

---

I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.

0 Answers   NCC,

---

What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.

0 Answers   NFL,

---

what is differents between static stablizer and servo stablizer

3 Answers  

---

how the frequency was generated in power station

2 Answers  

---