differentiate wired and wireless communication.
differentiate co-channel and adjacent channel interference.
Answers were Sorted based on User's Feedback
Answer / harshkaushik
wireless communication is simply a medium to communicate
from one device to other without having a physical link in
between them
wired communication is the medium of communication in which
we use guiding structure like coax , optical fiber or
twisted paired cable as a medium of transmission
co channel cells may be defined as the cells that are having
same frequency the interference resulting in between the
signal from co channel cells is co channel interference
while adjacent cells are those cells that are having less
separation frequency from the desired channel the
interference in between the signal from adjacent cells is
adjacent channel interfernce
| Is This Answer Correct ? | 6 Yes | 0 No |
Answer / bindhu
any 2 devices connected with physical media like copper ,
coaxial wires is wired n/w and a n/w in which comm'n is
carried out via air as medium is wireless n/w.
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / e.naresh
co-channel interferance is""caused in a channel due to the crosstalk from two different transmitters which are uses the same frequencies""
adjacent channel interferance is""caused in a channel due to extra power releases/dissipates from a signal in adjacent channel""
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / hemant jangir(future of india)
In wired communication we can not use modulation technique
but in wirelees technique we use modulation technique,and in
wired communication we can transfer one signal at a time but
in wireless technique we can transmit a no of signal
simultaneusoly
| Is This Answer Correct ? | 4 Yes | 5 No |
At what voltage does land line telephone operate?
Which of the following amplifier compensates for drift? A Low gain amplifier B High gain amplifier C DC amplifier D Differential amplifier
wht diff bet single & three phase?
what is colur code of resistor value 5.6kohms
A Square matrix each of whose diagonal element is 1 and each of the non-diagonal element is zero is called
what is the reason of RDI alarm in microwave link?
if UT=4v & V LT=-2v the hysteresis voltage is equal to......?
What is cache coherence?
WHEN +VE VOLTAGE ON THE GATE P-CHANNEL JFET IS INCRESED DRAN CRICUT WILL BE WHAT CONDITION
What is the difference between CAT 5e communication cable & CAT4 Communication cable
no. of interrupts of 8051 excluding reset.
What is meant by bidirectional or half-wave ac voltage controller?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)