Answer / sunil basha

injecter pressure is 220 kg/cm square

Answer / subhasish das

INJECTRO PRESSURE IS 220

Answer / ravi kumar

200 bar

Answer / ali

2000-2200 bar

Answer / pavan kumar

180 bar

Answer / sujeeshkumar

different vehicle has different injecter pressure , for example CRS engine has got pressure in between 1800-2800 & non CRS as got 220-800 bar

Answer / santosh rajbhar

2000-2800 bar

Answer / a.rex silvester

600 bar.....

Answer / balaji.n

150 kg/cm

In a synchromesh device, when members G1 and F1 are slid to left and cones M1 and M2 are in contact, a) Direct gear is obtained b) Second gear is obtained c) Third gear is obtained d) Reverse gear is obtained

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

Explain various types of breaks.

0 Answers   Ashok Leyland,

1 TO 65

0 Answers   RRB,

The main disadvantage of sliding mesh type of gear box is a) High noise level b) Low mechanical efficiency c) High skill required by the driver d) all of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

WHY THE COLOR OF VEHICLE TYRES ARE ALWAYS BLACK IN COLOUR. IS THERE ANY THING RELATED WITH HEAT CONDUCTION?

2 Answers  

The number of arms provided to the Cross of the Hook's joint is a) 1 b) 2 c) 3 d) 4

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

automobile

2 Answers  

Which conduct faster heat among steel, copper and brass?

0 Answers   GM General Motors,

CRANK shaft to be fixed to the engine, ? (1) Perpendicular CAM shaft (2) Inclined to CAM shaft (3) Parallel to CAM shaft (4) None of the above

3 Answers  

How bhp can be calculated in si units?

0 Answers  

Propeller shaft is used for the purpose of a) Transmitting the drive from the transmission to the bevel pinion of the final drive b) Transmitting the drive from the crankshaft to the road wheels c) Transmitting the drive from the transmission to the road wheels d) Transmitting the drive from the crankshaft to the bevel pinion of the final drive

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,