Why combustion chamber is used in gas power plant cycle? What will happen if compressor output is directly provided to gas turbine?

3 Answers  

---

hi fiends i am a diploma engineer(mech).now i am preparing for b.e mech part time course. could be send me entrance questions paper fo me .'sureshscad@rediffmail.com'

0 Answers  

---

how much safty of chiller?

2 Answers  

---

sir iam doing diploma in mech.engg i need a details of jcb 3dx model plz sent me detal in my email id- rahulchugh33320@gmail.com

0 Answers  

---

what is diffusion heat transfer

2 Answers  

---

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers  

---

thermal engg

0 Answers   NTPC,

---

What are examples of mechanisms?

0 Answers  

---

what is technology use in bikes

7 Answers  

---

What would you consider to be the most important aspects of this job?

1 Answers  

---

how gravity filling machine is designed

0 Answers  

---

What is an EN Material. What is the difference of EN8, EN24, EN40.

5 Answers   Aeronautical Society of India, Ecil, Finearc, Saint Gobain, Scitech Centre, Universal Engineering Works,

---