Answer / saradbashyal

by usuing capacitor bank
by usuing reactor
decreasing the induction load
increasing the size of the conductor

Answer / sms

1. Proper Selection of Electrical Equipment's
ratings /conductor size.
2 Reduction in line losses.
3. Using CVT's.
4. Uniform Load Distribution.

Answer / r.sanjai

To use voltage Transformers. for maintaining Constant volatge.

Answer / a.b.kartik

1)Improvement of power factor (using capacitor bank, synchronous condenser, & phase advancer)
2)Minimize the corona loss(reducing by increasing both conductor size, conductor spacing)
3)improvement of string efficiency
by above method to maintain standard votage in power system

Answer / mukund

also maintaining balanced load

what is difrent between earthing and ground

4 Answers  

Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?

0 Answers  

what is the difference between earthed cables and unearthed cables

2 Answers   Bhel,

what is 'A' Check & 'B' Check ?

2 Answers  

what's the outstanding feature of universal motor?

2 Answers   Tanfac,

What is the name of oil which is used in transformer?

3 Answers  

Why is a thicker conductor necessary to carry a current in A.C.as compared to D.C. ?

1 Answers  

WHY THE +VE POLARITY OF 48V DC POWER SUPPLY IS USUALLY GROUNDED?

1 Answers   Tulip,

we have two 11/.433 kv. distribution Transformer rating as 1000 kva & 500 kva , i wants to run parallel both transformer. both transformer impendence voltage is 5.24%, How can we run both t/f, & how sharing the load

3 Answers  

What types of I/O have you designed? What were their size? Speed? Configuration? Voltage requirements? Process technology? What package was used and how did you model the package/system? What parasitic effects were considered?

0 Answers  

3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??

0 Answers  

Why different values of B’s (magnetic flux density) are chosen for DC machines and Induction Motors?

1 Answers