Answer / nishat fatima

When an mineral oil is burnt hydrocarbon gases occurs, as
oil is in the liqiuid hydrocarbon form so when it is burnt
hydro carbin gases are extracted

what is power factor

7 Answers   Eskom,

---

As per which Indian Standard induction motors are manufactured?

2 Answers  

---

Igfet is a

0 Answers  

---

What is the range of the stator resistance of 3 phase induction motor?

0 Answers  

---

What are the types of lighning arrestor protection system? how to choose that according to load?

2 Answers   SPL,

---

A 11 KV motor is working. if the supplay is fail. what will happened with it's breaker? Trip / remain the same condition?

4 Answers  

---

How can transformer oil be used in transformers with voltage rating above its breakdown voltage?

2 Answers  

---

what is the setting of locked rotor in HT motor ? (answer expecting in percentage)

0 Answers  

---

tell how current tranfomer works

2 Answers  

---

Energy metering: On the property I am renting, the supply voltage is 2 x 110 volts. These 2 x phases enter a energy meter which then exit the meter to over head lines to my house. Question 1. The meter is single phase 240 volts but is being used as 2 x phase(2 x 110volt), is this acceptable? if not, please give me the reasons. The meter details are as follows: 60Hz 15amp Imax 100 amp Kd 3,6 Wh/R 1 fase 3 hilos Model FX 231. I think it was manufactured in Brasil From this meter, the cables run along over head aluminum conductors,I estimate the cross sectional area to be 25mm diameter, but the neutral is only about 10mm square diameter, which cover a distance of 170 meters and then terminate with an underground cable of 65 meter length, total length = 235 meters. There must be a huge voltage drop over this length. This line is protected with 2 x 200 amp aluminum fuses after the meter, there is no main switch in the distribution board. These 2 phases connect directly onto 2 busbars. Surely the neutral should be the same size as the conductors if not more? Question2. What are your thoughts about this installation, should there be better protection, is the neutral too small? During the night, the lights dim then brighten all the time, this cannot be good for my electrical appliances. In my home, I only have a small electric geyser and fridge, my stove works off gas. But when i use other appliances like the washing machine or microwave oven, the light dim. The internal wiring of this house is done with solid hard drawn copper wires and of course, they have to be under rated. I am a retired electrician by trade, but not on the metering and over head mains side, my experience is on the factory maintenance side of things. Your expertise on these matters will be greatly appreciated. Please inform me how to rectify or make any improvements Kind regards, my power bill is very expensive, so I need to know how to bring it lower. Kind regards, Brian

1 Answers  

---

what is the value of current as well as voltage upto which we will not feel shock and why?

3 Answers  

---

hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx

0 Answers   Ansaldo,

---