Answer / shishir.s.kadam

its L/D <= 20 or 15 for finding depth of beam

Answer / ronak shah

it is depending upon the, how much load considering on the
slab. if it is indestrial, commerical or residential
project. live load, dead load, wind load so many critria
effect the thick ness of the slab.

How to find the concrete volume in sloped footing??? illustrate with example

1 Answers  

---

how many covering can be taken in the beam,column & slab also stair-case?

6 Answers  

---

How to estimate the shuttering material requirement for a slab and beam and shear wall..? Please send thumbrule to estimate material required ( Plywood, Ms plates, runners, acrospans, jacks)

0 Answers   Sumadhura Infracon,

---

How much wastages taken in 1. cement 2. steel 3. fine aggregate 4. coarse aggregates (10mm, 20 mm)

0 Answers   Wonderla Holidays,

---

How can we calculate quantity of slab, beam @ column ? Beam should be calculated by deducting slab thickness or slab should be calculate in to in ?

5 Answers   SMC,

---

Rate analysis of Design mix concrete M50 and M60 DMRC

0 Answers  

---

how much cubic feet cement contain in one bag

12 Answers  

---

which tie is used in binding of steel double tie or single ti?

1 Answers  

---

what is the basic difference between a singly reinforce section & a doubly reinforce section?

11 Answers   L&T,

---

1.DIFFERENCE BETWEEN NOMINAL MIX AND DESIGN MIX? 2.WHAT IS MEANT BY STRUCTURAL DESIGN? 3.IN STAAD WHY WE RELEASE MOMENT TO A MEMBER? 4.ON WHAT BASIS PARTIAL FACTOR OF SAFETY ARE DECIDE?FROM THE LOAD COMBINATION? 5.WHY WE PROVIDE EXTRA BAR & DEVELOPEMENT LENGTH AT TOP? 6.FULL FORM OF SPT & SMB? 7.WHAT IS MEANT BY ITP IN A CONSTRUCTION PROJECT? 8.WHAT IS LEAST COUNT OF THEODOLITE SURVEY? 9.WHAT ARE THE CAUSES OF FAILURE OF FOUNDATIONS AND REMEDIAL MEASURES? 10.WHAT ARE THE VALUES OF COMPRESSIVE STRENGTH? 11.STEEL CALCULATION FOR FOOTING,BEAM & SLAB? 12.WHAT IS MEANT BY GANTRY GIRDER? 13.IN SITE HOW WE CAN IDENTIFY THE ONE WAY, TWO WAY SLAB? 14.DIFFERENCE BETWEEN ANCHORAGE LENGTH & DEVELOPEMENT LENGTH? 15.BEARING CAPACITY OF STEEL SHUTTERING?LOAD CARRYING FOR SHUTTERING?

3 Answers  

---

what are the advantages and disadvantages of using bentonite slurry in bored cast in situ piles, both in terms of design and execution point of view.

2 Answers   Punj Lloyd Ltd,

---

How to calculate density of 40 mm coarse aggregate, in mixing ration 1:1.5:3? Please explain calculation for density

0 Answers   Ansal Housing,

---