Interested to Buy Any Domain ? << Click Here >> for more details...
How much width of the land shall have to be left below the EHT line of 440 kv as per the rule. i am told that a corridor of 35 M width is to be left free below 220 kv line. please confirm
1 3365if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
1981Dear Sir / Madam, Actually we requied 64 A MCB, But i have 32 A MCB = 2 No's this two i have to make series connection and we usw any place? isit possible or not......
4 7595if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value
1936when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
2180Post New Electrical Engineering Questions
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
Bimetal strip used in overload relay what is that,which types of material used for that & percentage.
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
what are factors to be consider to design a HT & LT motor?
please send 5yearje solved papers on my email himmatsinghnathawat@gmail.com
State the methods of improving power factor?
Why can't we parallel Voltage transformer secondary circuits?
What is sink and source?
I COMPLITED MY B.TECH AND 10TH CLASS WITH 70%MARKS BUT 12TH CLASS 55%MARKS..CAN I GET INDIAN RAILWAY RECUREMENT EXAMINATION?
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
How earthing/grounding done in aeroplanes and ships.
What are the different circuits in thermal power plant?
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
why generator efficiency is more in swinburnes test?
I want to put this query to SENIOR & EXPERIENCED ELECTRICAL ENGINEERS. 1)I want to know about the control circuit diagrams for control panels. I found it difficult to understand. Is there ant booklet through which we can learn the circuit diagrams? 2)I want to learn about conduiting, laying cables, preparing cable schedules and various techniques which is the part of building infrastucture(construction field). I don't have any experience in this area. I have experience in control panels only. that's why i am not getting any opening in building infrastucture (construction field).Can I get the job in this field as Trainee Engineer? How to enter this field? I need job in PUNE
