can any one suggest me the tilt angle of my solar pannel ?? or tell me how can i know the fix tilt angle of my solar pannel?? my cordinates are 31.503629,72.993164.
1368What is the criteria for deciding whther fire wall is required between two power transformers
1 3186How Can I calculate for the photometrics requirements for a street lighting? Data given are: 45 units of 6 meter light pole with 150 watts metal halide lamp, 220 volts and installed in a promenade area.
1409why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
1670I have calculated load for an office building which is 1200 KW as all the load is single phase therefore its 1200 kw single phase. Now i have to design Transformer and Generator for this load Please kindly give me exact answer that how much capacity of Three Phase Transformer and Three Phase Generator is required for this load.
3 5209Post New Electrical Engineering Questions
sir please send me iocl written test paper in my e-mail account. i'll be obliged to you........ thank u roshan
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.
in parallel operation of power transformer why the distance between power transformer and capacitor bank feeder is necessary to know
Differentiate between kirchhoff’s first law and kirchhoff’s second law?
why ten delta testing is carried out on power transformer
How to back charge the Gas turbine generator
What is the drawback of class b amplifier? How is this minimized?
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
sir, I am from EEE branch.On feb 17 iam going to write an Exam for hindustan petrolium corporation Ltd.So plz send me the written exam pattern/Q's/interview questions.please mail to eee_dharmendra@yahoo.com
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
what are the factors to be considered while design the breaker either HT or LT??
how to calculate units consumption for a 12 hp motor /hr.
What is meant by Load Encroachment in OHL Feeder Protection?
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?