How much weight an electrical engine can pull??1251
what is daiod4 8395
what is the multi strand cable size? 0.45mm is area of one strand & 370nos of strand.1 2421
what is the HT motor current setting (Motor protection relay)aganist FLA If the capacitor is connected in parallal to the motor to increase the P.F from 0.89 to 0.99. the setting is to be reduced. what is the formula for to calculate the current.(FLA - CALCULATED CURRENT!= )1 7144
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors1044
we know that dc motors are more superior then three phase induction motors in torque generation though they are not much used in industries why?5 5221
control diagram of star delta starter5 6423
Advantages of Induction Motors2 2519
Is MV canble armour can be earthed at both ends?2 2482
What are the reason of unbalanced secondary voltage of HT transformer 33kv/6.6kv ? Incomming voltage is balanced.33kv each secondary voltage 6.6 kv 6.4 kv 6.4 kv At no load conditions.1 2597
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
how to combine two linear transformers...............1 1265
DO MEGGER TEST APPLIED ON SURGE ARRESTOR? IF YES THEN WHAT ARE THE ACCEPTED R VALUE REQUIRED FOR SURGE ARRESTORS FOR VOLTAGE LEVEL 11KV, 33KV2 7652
in small capacitor we use uf( micro farad) and in big quantity we used kvar. i want to know that in 1 kva how much will b uf(micru farad).2 3633
How to measure current and voltage in an ELV circuit
What is CCT (Correlated Color Temperature) ?
What Normal(Tangent) towers and Tension(Cut-point) Towers?
Why High voltage are generate noise ?
how can you calculate fault level ?
where was current transformer protection units used and why??
when will be the iocl interview results ifaced the interview on september 8 th
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
How to Calculate Transformer Earthing Electrode Rod Size both Body and neutral Earthing ? Any Standard Formula? Please Suggted
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
How to design the earth grid for lightning protection in an industry
can any tell me why slope 40% and 80% is calculated in differential protection?
What is a difference between indoor transformer and outdoor transformer of same rating