which one is rotating transformer-single phase induction motor or 3 phase squirrel cage motor?
1 4641i wasted one year for the job after completed my btech what can i say about 1year time in interview
2174A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
2528IT IS DESIRABLE THAT THE INCOMING MACHINE SHOULD BE A LITTLE FAST AT THE TIME OF SYNCHRONIZING.EXPLAIN?
1 3527WHEN TWO ALTERNATORS ARE OPERATING IN PARALLEL, EXPLAIN WHY IT IS OBJECTIONABLE TO OPERATE ONE AT A LEADING POWER FACTOR AND ONE AT THE Lagging power factor?
1 3868WHAT R THE SAFETIES IN A HIGH TENSION PANEL N LOW TENSION PANEL. ALSO WAT SAFETIES R THERE IN A 200 KVA TRANSFORMER?
2322Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
2141why the voltage is in digit of 11/33/132/220/440 please send me on shukrerabbi_abkhalil@rediffmail.com with thanks
3 5886Post New Electrical Engineering Questions
What are the basic properties of signal flow graph?
How much earthing frequency is capable?
hai...... tis is Hemanth. jst now completed electrical engineering... i wanna to apper for ap tranco exam... plzz send me the previous q's paper link......thanx in advance.
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
what will happens if one phase is missing for 33/11kv power transfomer and why?
i need list of swg(standard wire guage) or area of conductor v/s current carrying capacity of conductor copper & alluminium...
What is the lower limit of break-down voltage of converter transformer.
How we calculate the size of ht cable for any transformer
what is the ground fault relay,which purpose it will be use,clearly tell me plz
how to select overload-relay for perticular motor 1.for D.O.L. starter 2. for Star-delta starter ????
how electical engineer is related to apsrtc (general) post? if they ask a question in interview as why did u choose this job what shd be answer
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
How to select the proper VSD to operate high inertial load
please give me all the Alarm .Trip ,Safety Relays & Conditions of UPS Systems mail me on ashokbabunhce@gmail.com