From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
1039In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
1036how the specific fuel consumption of 320 kva deisel genarator set (explain with formulas please)?
RRB,
2 4065Is there thumb rule to calculate how many Insulators to be used for Transmission line of different volatges
CS,
3 4104Post New Electrical Engineering Questions
the typical output of a solar cell is........
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
in shunt clippers why a resistor is used in sereis with the input
what is conductor constant of raccun conductor
What does bode plots shows?
hi , i have 150 kw loud and we need 50 m cabil,i want to know wich size cabil we use. thanks
how many joints are allowed in underground HT cable of 1 KM
Explain cmrr?
Under wat condition statcom operates as an inductor for the transmission line?
How do we calculate transformer oil in liter from the rating of the transformer.
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
What are the main advantages of generalized error co-efficients?
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
