how the ac voltage are selected like 220v,415v,750v,1000v& 1.KV,6.6KV,11KV,33KV,66KV,132KV,220KV & why these are selected like these orders
2 9445Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
2093In alternator generally we give DC voltage to field of alternator but field (excitor)produce Ac & converts into DC by rotating rectifier(RR ) then fed to rotor .my question is why we cannot give dc voltage directly to rotor instead of Excitor & RR ?
1 3796What is the difference between IS:1554 (Part 1)/1988 & IS:694/1990 ? What do these two standards specify about?
2 21199Post New Electrical Engineering Questions
What is servo motor? what is its purpose?
what is meant by moulded case circuit breaker ?
What is the difference between the transmission line and distribution line?
Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.
diameter of cable and core is doubled then the value of capacitance is
give me atleast four differences between circuit and network
How RTCC panel is working and give single line diagram for RTCC with transformer?
what are carbondioxide and dcp used in fire extinguishers
What are the types of control system?
Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.
how ct burden,magnetising current,ratio and knee point voltage are related & derived
can some one clearly explain why -48 volt DC use in telecom site????
If a high resistance fault occurs,then what are the changes will happen in the system?
What is the difference between a verilog task and verilog function?
What is the restart inhabit setting in ABB spam150c relay (Motor protection relay)