What is the diameter of electromagnetic field around a 11000/415v transformer ? Dose it affect people who live 3-4 meter beside it?
2177when we start the tube light, then it takes initially 1100 volt, after glow it takes 120 volt?(when we give 220 volt a.c.)
3 6719PLEASE INFORM ABOUT THE IDEAL TEST RESULTS OF MAGNETIC BALANCE TEST OF TRANSFORMER 33/11 kv DELTA-STAR T/F
2262One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?
1 4560when meggering a 3ph,480v oil reservoir heater on a regen gas compressor, why do I get a reading to ground when meggering phase to ground? shouldn't it read opened or is there something that makes it read closed? on the same heater, when ohming, it reads open. thanx
1 5464Post New Electrical Engineering Questions
Can we put 3 layers of cable tray while installing tray
Define damping ratio.
What is ramp signal?
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
What is bode plot?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
pls tell me function of closing coil of A.C.B.
Why single phase induction motors are not self starting ?
how is calculated the quantity of weight in hot test xlpe?
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
hello friends..... any one have papers or any study materials?sail ,hpcl...?
Pl. share your experience about industrial-electronics repair of machine tool.
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current