IF 3 NOS.OF HEATERS,3KW CAPACITY EACH,1 NO.HEATER CONNECTED IN R PHASE,1 IN Y PHASE AND 1 IN B PHASE.THEIR END POINTS CONNECTED IN STAR.IF I CONNECT THIS STAR POINT TO NEUTRAL OR DO NOT CONNECT TO NEUTRAL.WHAT WILL THE DIFFERENCE.
3 4114In 2500kva transformer how much is the withstand High voltage power frequency between primary to secondary and earth? And secondary to primary and earth?
1 3017I want to know if it is possible to use Variable Frequency Drive to reduce the current required for starting a motor?
3 2796How magnetic balance test of single phase transformer is done,Especially in ESP transformer rectifier set.
Bhel,
2 3701Post New Electrical Engineering Questions
What is the diffrence (Technical & Construction ) between CBCT & Normal CT?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
why Lightening Arrester Probe sharp at Top of telecom tower.
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
what is ps impedance test
explain comutator action in detail.thanks
What is turn ratio of a transformer?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
wish of these transformer uses oil?
ratings of lightning arrester
As we use capacitor bank in 3ph ckt to improve PF, can we use capacitor in single ph domestric use, in house we have Fan,Mixer,electric cooker,iron,tube choke they also lag the system,because it is inductive load. if it is possible to improve PF of single ph system-- if yes- type of capacitor to be used,connection diagram, working in detail. if no-- list it.
how much allowable resistance that can be difference in motor all coils?
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
After synchronization with grid what is the demand value QKVAR and how we will maintain that?
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain