Interested to Buy Any Domain ? << Click Here >> for more details...
What are types of structural connection? Explain briefly please? I know only types.(Shear connection and Moment connection).anybody can explain briefly please.
1 4323dear sir, please send me HPCL(mechanical stream) papers to my email-id(shravani.mech@yahoo.co.in) as soon as possible.
1 4351what questions should be asked to a mechanical maintenance technician
Alfa Laval, AMH, Exxon Mobil, Kharafi National, Sabic, TATA, Windalco,
6 77326What are the type of questions posed to a mechanical student in an interview?i am having my infosys interview on 26th and 27th of june.please reply me.i am in my b.tech final year.
4 12010Is There Any guy give me detail information regarding "ISO/TS-16949-2002 " /TPM/QMS/SPC/MSA ???
3 7065i want how the pattern of interview goes on for mahindra& mahindra company? plz send me as soon as possible
2 4919If a person is working in R&D organisation but he has not been involved in R&D activities. So Which types of questions may be asked if he wants to get opporunity in mechanical R&D activities?
3364Post New Mechanical Engineering Questions
"What is fuel oil viscosity, specific gravity?"
Which outer cover is on the welding rod?
What does afbc stand for?
Which pipe should I use SAW, ERW or seamless if I have the following constraints I have to transport methane gas Size is 8” Corrosive environment Sulphide is present Also tell the cost comparison
Define nusselt number [nu].
Please advise your reasons for applying for this role and why you think you are suitable?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What do you understand by heat treatment?
Under what condition the work done in reciprocating compressor will be least ?
What causes friction in the cylinder?
i am studying mechanical engineering third year.. i want to study ine year marine bridge coure.. is that good for me?
What is the material used ball screw rod
hi friends kumar here if anybody of u have essar placement papers than plz send it to me i need it urgently..ok mail id is kskalyani@gmail.com
What is wrap-around?
plz anyone provide me the sample test papers of ONGC as of i m from Mechanical engg bakground and would be appearing for the test in the june 2010. My email id - neeraj_94312@rediffmail.com
