If we measure the pressure of Air in duct with the help of Pitot tube attached to manometer (pitot tube) whose one end is in atmosphere and one end is in duct and manometer shows some head whether it is Static head or Dynamic Head or (Total head=Static head + dynamic Head). and if it is total head in which static head is zero then how static head is zero.
2 4695i am going to face interview of hal so plz any body send me the sample questions of hal .... plz reply to girish.salaga2@gmail.com
HAL,
1661sir, i need some help by you. sir i want to know there are any industry that give six month training on the basis of entrance examination. sir if there are any .pls send me ans on my email-id sk12005@rediffmail.com pls.
1592placement recrutement process for renault nissan and want model aptitude paper
Ashok Leyland, HF, Microsoft, Nissan, Renault, Renault Nissan,
2 26664Post New Mechanical Engineering Questions
if we not carried out B check at mean time in DG set what will be happen?
can hyrogen be used as fuel in parral with coal in boliers
interviw tips for bhel supervisor trainee
Why axial flow compressor is preferred for gas turbines for aeroplanes ?
What is the formula for 1 HP of a two-cycle engine?
What is diffrence between star & delta connnection in practical situation in submersible pump?
Which conducts heat faster steel copper or brass?
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
What is the purpose of increasing the pressure on the F.O. system of the engine?
As compression ratio increases, thermal n increases. How is thermal n affected by weak and rich mixture strength ?
What is the purpose of air blow?
Explain the nuclear reactor.
How engine design needs to be changed to burn lean mixture ?
Working Detail of enging?
hi this is swaroop i appliled for masters in us for mba and my ielts score is 5.5 and no gre and i have 14 backlogs