what the raw mill1 2980
thermal engineering,strength of materials,design of machine element,3 14437
3-4 questions on optical fiber : data based.
what is the thermodynamics?8 8955
generally how much percentage is required to sit in exam of PSU'S for mechanical engg. candidate (general category)1654
how to calculate bearing pre-load?1768
Why u want to leave the job? & Why u want to join our orgnization?3 4685
what is thermodynmaics11 6390
Sir, In the current session I am attending the Junior Engineer Exam in Grade II for Mechanical Engineering. If it possible. Please sent the Past Exams Question on my mail. It is so useful use to me.
what's the difference between moment of inertia and mass moment of inertia?4 10311
can we say all tapered pipes as nozzle?8 4383
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.856
In General please do read newspapers.And be thorough with 10th history and Geography.Biology also785
what is the equvalent indian material code for EN10025/2- S75JR
Dear sir-I WANT LAST FIVE YEARS RRB-CHENNAI QUESTION&ANSWER PAPER IN J.ENGG(GRADE:II)-MECHANICAL ENGINEER
why does polytropic efficiency of a compressor decrease with increasing flow rate ?
What are the causes if one cylinder in a diesel engine has a high temperature?
What is cri pumps & mechanical sael
rrb junior engg mecf questine papers
I am requiering interview questions regarding Close Ferro Crome Furnaces
workingh principle of valve timing chart for cummins engine
what is the responsibility of assistant manager in welding in goa shipyrad company?
what shows avribiations related to bearing blocks
Why preferred Production than Drilling?
What is the common source of leak in stern tube
How the speedo meter ratio was decided for vehicle?
Give five differences between suction and discharge pipes?
Where can i see model papers for NLC graduate engineer test and RRB section engineer test