How to design staircase.plz tell me formula for the design the staircase.916
how to carry out rate analysis for RCC work in column using M20 ?1 1993
Whats be the minimum foundation depth of multistoried building as per height of building in individual footing?920
how much weighs a square feet of slab of 5 inches thick2 1999
minimum thickness of pcc 1;4;8 for road concrete1 5282
Coverage of 25mm.thick ratio of 1:4 cement mortar?896
For M30 grade how much cement bags will need for one cubic meter qty1 1942
How to calculate cement and river sand material Qty for waterproofing base coat and finish coat1002
i have a interlock pavement work.i need to compact about 2000 sq metres of sub base grade c of thickness 15 cm.what is the amount of water required for compaction ??
what is mean by reestimation?
a) Difference between Ghol , Chimney & fly ash bricks b)Floor to floor height is 3m , rise=15cm , tread 20 cm , how to design staircase means steps landing
which is the cheapest type of flooring (say for using for 6 months in a factory building & dismantling it)?
what is the meaning or full form of 12T13 cables used in prestressed bridges
How much cement,sand,bricks and water needed for 1square metre brick work?
cement and sand required for one block of size 0.23*0.15*0.46
What quantity of 1.0 m3 bricks required?
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
What is the difference between one-way slab and two-way slab?
how to calculate steel for slab or footings?
Explain moment of inertia and its importance.
very simple or less time consuming formula for reinforcement calculation by moment
How much wastages taken in 1. cement 2. steel 3. fine aggregate 4. coarse aggregates (10mm, 20 mm)
What should be the lap length in raft if height of raft is 0.800mm ...it couldn't b 50D or 40D...we just have to join upper and bottom reinforced...is there any formula for determine it...