WHY DO YOU WANT TO WORK HERE?8 4839
WHY SHOULD WE HIREYOU OVER THE OTHERS WAITING TO THE INTERVIEW?3 4452
GIVE US YOUR FULL DETAIL OF THE FOLLOWING… FULL NAME.. PERMENENT MAILING ADDRESS DIRECT CONTACT NO E MAIL ADDRES.965
WHAT IS YOUR CURRENT SALARY850
DEAR ALL I HAVE AN OPURTUNITY IN WORK IN AFGANISTAN? MY QUESTION IS WHAT IS THEPRESENT SAFETY POSITION IN AFGAN? HOW IS THE COMMUNICATION AND BANKING FACILITIES IN AFGAN? HOW IS THE CLIMATE ABOUT AFGAN? ANYBODY KNOW ABOUT THE ABOVE DETAIL PLS TO SENT THE ANSWER. IF YOU ARE INTRESTED TO SENT THE ANSWER PERSONALLY PLS TO CONTACT MY MAIL ALSO. @ firstname.lastname@example.org 2567
what is periode of deshuttering for different area of slab6 35728
To construct 100sq.yard what will be the cost in detail pls2 3267
Write short note on construction programme for pile foundation.
procedure for preliminary selection of size of column of 5 storey building
what is w/c ratio in dry lean concrete for m10 mix design
150mm bricks size how many use 4.14 m3
how much one carpenter can doing shuttering of slab in one day
in a corner footing of a building, column lies in one corner. in this condition i want to know if the reactive pressure of soil will be uniformly distributed throughout the footing or will be uniformly varying as in the case of eccentrical loading.
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
Which tests are performed on soil to decide the type of foundation to be provided.
types of laps in column
How do we get this formula Ast=(0.5Fck/Fy) into(1-(in sqrt(1-((4.6Mu)/Fck.bd^2))into bd Fck=grade of cement i.e M25, M20 Fy=grade of steel i.e.Fe415,Fe250 Mu=moment b=width d=depth
) Design a gussetted base for a column section consisting of one sc 250 with two cover plates 300 x 25 mm carrying an axial load of 2500 KN. The S.B.C. of soil is 250 KN/m2 and the permissible bearing pressure on concrete is 4000 KN.
Suggest how many column, beem, etc required for 30 mtrs x 21 mtrs width x 8mtrs height for industrial shed of ground floor. I want to know the quantity of tmt steel consumption and Concrete consumption for budgeting
what is grade intersection?
when reinforcement binding completed if there is more cover than the required what is the solution to reduce the cover?
difference between fc and fc'?