What is R/X ratio?
I have heard that this ratio is higher in a radial
distribution system.Why is it so?
I would appreciate a word.
Thank you



What is R/X ratio? I have heard that this ratio is higher in a radial distribution system.Why is i..

Answer / jagadeesh

X/R ration means (line reactance/line resistance)
for short transmission lines it is X/R<3.0
long lines it is >3.0
because long lines length of transmission line is due to
this inductance is more(L directly proportional to length of
line)
for short lines L is low due to this X is low (X=2&#8719;FL)
some value divides low vale it is always high(ex: 1/0.1=10)

Is This Answer Correct ?    15 Yes 24 No

Post New Answer

More Electrical Engineering Interview Questions

what happens when you connect a.c and d.c supplies

1 Answers  


In induction machine when the load increase the current will increase .why? what is the relation ship between the sleep and current drown by stater?

1 Answers  


can any tell me how to do wiring connection in L&T 3ph 4wire E301 CT operated energy meter, what is P1,P2,P3,P0. M1,M2,M3, L1,L2,L3.

2 Answers   Bhartiya International,


need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.

0 Answers  


what is the function of Droop CT and where it is used?

3 Answers   Lanco,






i seen a 132kv/11kv transformer,and thier is a sugar factorys 10MW EXPORT PLANT,MY QUESTION IS THAT WHEN THEY EXPORT ELECTRICITY THEY USE THE SAME TRANSFORMER AND THE CONNECT IT TO 132/11KV TRANSFORMERS SECONDARY SIDE CAN ANY ONE EXPLAIN IT.. THE TRANSFORMER IS OF KIRLOSKAR MAKE AND IT HAS TAP CHANGER.

1 Answers  


Why CBCT rating is 50/1A

0 Answers  


What happen if transformer neutral path get removed ?

1 Answers  


LT cable fault checking instrument is available? where and how to get it.

2 Answers  


what is the principle of dc generators?

7 Answers   CPCL,


what are all the components required to assemble solar panel other than pv cell?

0 Answers  


what is meant by power and distribution transformer ?

0 Answers   CG,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)