Answer / aman kumar

Current was not circulate in transformer core magnetic flux does. But if you try to say eddy current then there was insulation b/w every strip of core plate which despite it into heat.

Our Alternator nameplate specifies a power factor of 0.8. When the Alternator is on light load, the bus bar voltage rises to 11240 volts, whereas the standard value is 10500 volts. Is it ok to increase the power factor to 0.85 or 0.9. I am afraid because the power factor on the name plate is only 0.8 ?

3 Answers   Escube,

---

what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?

0 Answers   BARC,

---

A transformer has negative voltage regulation when its load PF is A zero B unity C lagging D leading

1 Answers  

---

How does a television work?

0 Answers   Siemens,

---

why transformer fuse wire is very thin as compared to home fuse wire while voltage lavel is low

1 Answers  

---

Which is the best protection in case of shortcircut fuses or mccb ?

2 Answers  

---

What is BusBar integrity test and how it is conducted?

0 Answers  

---

For 6600/433 distribution transformer we apply secondary side 433 volts how much voltage in primary side.

2 Answers  

---

What should be the height of basement according to NBCC code?

0 Answers  

---

what is draiv work

0 Answers  

---

What are the effects of adding a zero to a system?

0 Answers  

---

hello everybody. please tell me the function of transformer bushing,s. i heared somewhere that it saved transformer winding from sky electricity. please tell me if that is right then how it work,s. Thank,s.

2 Answers   3EEE,

---