My present SMPS ( +12V, -12V outputs, 1Amp Rating ) was faulty.I donot have si

My present SMPS ( +12V, -12V outputs, 1Amp Rating ) was
faulty.I donot have similar model however i have two + 12V
SMPS available. Can i use both of these SMPS as a
replacement to present SMPS by connecting one of SMPS in
reverese polarity.

Question Posted / venkata rao

2 Answers
4677 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

My present SMPS ( +12V, -12V outputs, 1Amp Rating ) was faulty.I donot have similar model however ..

Answer / devdip guha mazumder

It is not possible to acquire -12V by just connecting the
SMPS in reverse polarity. It can be made -12V with respect
to Ground Zero.

Is This Answer Correct ?

9 Yes

0 No

My present SMPS ( +12V, -12V outputs, 1Amp Rating ) was faulty.I donot have similar model however ..

Answer / satish kumar dhiman

You have to Make common of + 12v of on power supply on -ve
of another supply than may be you get results.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electronics Communications Interview Questions

wht is charging gateway protocol wht is it functio

0 Answers ZTE,

In UMTS, which will control RRC protocol??

0 Answers Motorola,

what is the difference between electricle and electronics?

7 Answers Syntel,

A 12v regulated dc power supply has a voltage regulation of 0.5% find amagnitude of variation?

1 Answers TCS,

One FIU19(E) Flexbus LED is steadily on. What is the meaning? How can a Laptop PC be locally connected to a FIU19E? What is the maximum capacity of a FlexiHopper radio link operated by a FIU19(E), that is equipped with two 4x2M plug- in units? Which of the listed combination of indoor units support

0 Answers NSN,

Suppose in market 4n27 is not easily available so which opto isolator can I use at the place of this? What is 4n27

0 Answers

What is snubber circuit?

0 Answers

what is the different between gsm and cdma?

0 Answers Reliance,

Explain the difference between dcs & plc & scada?

0 Answers

Explain the effect of if in radio receiver?

0 Answers

Draw the schematic drg of how a data is transferred to control room from a field instrument....

0 Answers

In which of the following is an operational amplifier (op-amp) used? a. Oscillators b. Filters c. Instrumentation circuits d. All of the above

4 Answers

For more Electronics Communications Interview Questions Click Here