In a star(primary) to delta(secondary) transformer,how you
take the neutral point?
Answers were Sorted based on User's Feedback
Answer / antarjyami behera
We get neutral point from star connected transformer
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / dwivedi sandeepdhar
you can get the neutral point by using voltage grounding
transformer.
Is This Answer Correct ? | 0 Yes | 2 No |
In primary (star) u can easily get the neutral
point/earthing point & in the secondary (delta) u can get
the neutarl point by using Zig-Zag (V- connected)
transformer.
Is This Answer Correct ? | 1 Yes | 4 No |
In our domestic single phase line if you don't have a ground connection (earthing)how will you separately use earth in a specific power supply board.
what is "PE" earthing? and what do u know abt 16mm cable?
Due to velocity saturation, MOSFET reaches saturation a.Before Pinch off b. After pinch off c. At Q point d. Before Q point e. After Q point
why transformer does not obey ohm law?
what diferent amoung three phase supply?
difference between microprocesser and microcontroler
how define the torque in ac drive. from electrical side in the drive friquency ,voltage and current three factor is there.
How can make a star delta with Rstar delta feeder ( ( 4contactor & one timer ) pls answer with digram (power &control digram)
why the transformer primary and secondary windins vector groups vary? why it is something like Dy11 and not as Dy or Yy...
what is IP55,IP65
Why is it that bus reactors are not accompanied by a neutral grounding reactor whereas a line shunt reactor is? PGCIL does so.
why in america the supply frequency is applied as 60 HZ. but in india we use 50 HZ.
1 Answers Elcom International, HCL, NTPC, OMC,