Answer / prakash veer singh

LOP sensor : Low oil pressure sensor
if sensor sence low lube oil pressure ,sent the LOP single
to AMF relay ,and AMF relay trip the DG.

Answer / nayeem csm-team

Lop sensor :.... low oil pressure sensor
it have another name LLOP sensor
LLOP sensor :.... low lube oil pressure sensor

Answer / b.h.sonawane

LLOP Means- Low Lube oil Pressure, this senser sense the
Engine oil pressure & transfer the information to Engine
Controler. If pressure not in proper range trip the engine.

Answer / thowsif s

LOP sensor : Lubricating oil pressure sensor.

Answer / vinay kumar

lop means lowlube oil pressure. It has a sensor connected
to oil pipe gauge. it senses the oil pressure and transfer
the data to AMF. It trips the engine if the pressure is not
in acceptable range.

Answer / gurwant

yes it is low lube oil pressure sensor if lekages of lub oil anywhre engine side or oil level low in sump then oil sensor give command to contrller & solonied switch cut fuel from fuel pump and shut down engine.

Answer / ashish

yes it is low lubricated pressure it tripes the D.G over
high pressure or over load

in trains i have seen the terminal which is connected at the top of the train is positive .where is negative ? track? i dont think so

9 Answers  

why they charge more bill for low power factor rather than high power factor

2 Answers  

why all transformer colour is same?

3 Answers   OPTCL,

what is power factor?

3 Answers  

V.c.b and a.c.b difference

4 Answers  

for compensate 315mh inductance ,how many capaciance required?

1 Answers   Mitsubishi,

Is there any local or International standards that prohibit the installation of earthing pit in the planters area where the earthing pit is subject to continues soak in water?

1 Answers  

what is the difference between dropout fuse and horn gap fuse. how to choose between them

1 Answers  

how can i determine the KVA/MVA rating of transformer precisely?? is there any standard test?????

0 Answers  

Why current leads the voltage in case of capacitor load? Why voltage leads the current in case of inductive load? Why both are with in phase in case of restive load?

3 Answers   TATA,

What is the function of under voltage release ?

0 Answers  

what material used made for the resistance,for the purpose of zero temperature coefficient?

2 Answers