What is FM200 Fire Supresion System??
Answers were Sorted based on User's Feedback
Answer / ramendra shukla
FM 200 is fire supresion system which is used to neutralise
the fire in closed areas.Normaly it is used in Data Centre,
server room or very critical areas of facility due to its
cost.
FM200 is name of Gas.When it is mechnically dressed
with ,Cyilender, nozzel,connecting pipes,support &pressure
switch called FM200 system.and mainly used in very critical
area of facility like-Servsr room,data Center ,and for very
imporant set up due to gas cost.
Funtion: when ther will be fire the gas releases on closed
area FM200 gas is having capability to minimize the absence
of Oxygen &as we know absence of oxygen fire can not take
place.
Is This Answer Correct ? | 28 Yes | 2 No |
Answer / suhana_t
The FM-200 Fire Suppression System is an engineered system
utilizing
a fixed nozzle agent distribution network. The system is
designed
and installed in accordance with the National Fire
Protection
Association (NFPA) Standard 2001, “Clean Agent Fire
Extinguishing
Systems.” When properly designed, the FM-200 system will
suppress
surface burning fire in Class A, B, and C hazards.
Is This Answer Correct ? | 11 Yes | 0 No |
Answer / sandeep.sekharan@yahoo.com
Heat absorption is the main extinguishing property of FM 200 system and oxygen replacement is secondary.
Is This Answer Correct ? | 1 Yes | 0 No |
what is the use of tertiary winding?
Which type of power plant is more easier to produce electrical power at economical condition?
Why the generating station rating is in KW though the rating of generators in KVA?
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
Why don't we provide SURGE ARRESTORS for Transformer feeders?
we have taken HV test of 2.5 k and Megger test on 11 kv HT cable.here it shows no fault but when we are charging the same cable with 11 kv supply why the VCB 11 kv gets tripped can anybody define the possible cause of fault ?
my question is that....few days ago i had installed a three phase motor starter for an electric saw.the motor will run and make the hydraulic pressure which will be goes to pressure cylender by up and down lever.two number of limitswitches are also installed on cylinder for safety of motor.now when the arm of cylinder reaches to the upper or lower limit it will cut the motor's line.and motor will be stop.now wana know that what will i do that motor runs continue after the limitswitch cut it down but it shold not be made any pressure.pls answer me in brief.
which plant has high load factor
What is the diffrence between ofline ups and online ups?
why generating voltages are of 11kv 33kv 22kv of 11 multiples
how to measure earth pit resistance
7 Answers BARC, BYD Electronic, Construction,
What is the difference between Contactor and Circuit breaker ?